Oxygen & nitrogen generation systems · ISO 9001 & ISO 13485 registered

PCI Gases Search
Menu

Home » Oxygen Solutions » Aquaculture

Oxygen Technology Markets

On-Site Oxygen Generators for Aquaculture

Aerial view of circular fish-farm tanks

Aquaculture

Why dissolved oxygen matters in aquaculture

Like humans, aquatic species need oxygen to survive. In aquaculture, oxygen is diffused into water to increase stocking density and production yields. Consistently higher dissolved oxygen levels result in lower mortality and higher food conversion rates. To maintain optimal growth conditions, it is essential to utilize an active oxygen management system.

Injecting high purity oxygen into fish and shrimp raceways, ponds, or tanks instead of ambient air provides significant productivity gains and reduces risks of mortality loss due to poor water quality. Typical aeration methods are very limited in their ability to provide consistent levels of dissolved oxygen (DO). Many aquaculture operations experience daily and seasonal low DO fluctuations. As DO levels decrease, they become inadequate for food consumption. This results in slow growth and leads towards higher mortality rates. The minimum amount of O2 required for a healthy pond must be greater than 4 mg/l (7 mg/l or more is optimum). To maintain ideal growth conditions it is thus essential to utilize an Active Oxygen Management Program.

Injecting pure oxygen directly into the water increases vital DO levels faster than is possible for air-based diffusion systems. Consistently higher DO levels thus result in lower mortality, better food conversion ratios, and the ability to increase stocking densities. Dissolved oxygen is the most important factor in achieving increased results and improving bottom-line profits.

Compare aquaculture oxygen generator models
PCI DOCS 500 oxygen generator installed under a shelter at a fish farm

> 4 mg/l

Minimum dissolved oxygen for a healthy pond

7 mg/l+

Optimum dissolved oxygen level

~50% less energy

Than a PSA of equivalent size and delivered pressure

Year-round

Oxygen produced right at the farm

Active oxygen management

Benefits of an active oxygen management program

Increased stocking density and production yields

Increased food conversion ratio results in cost savings from improved feed utilization

Minimized fish mortality from decreased disease rate and fish stress

Better water quality

Optimum growth rates

Increased production capacity due to reduced cycle time

Pumping cost savings due to reduced water re-circulation

Higher profits due to average weight gain and higher fish quality

On-site oxygen generation

Reliable, power-efficient oxygen supply for fish farms

PCI Gases DOCS (Deployable Oxygen Concentrator Systems) provides to the aquaculture customer:

What PCI DOCS delivers at the farm

A robust, reliable source of on-site oxygen generation regardless of the environment – cold or hot, dry or humid

A low-cost supply of oxygen for continuous, year-round needs with oxygen produced right at the farm

an efficient VSA oxygen (Vacuum Swing Adsorption) process uses a blower that moves air into an adsorption vessel at very low pressures and eliminates the need for an air compressor that PSAs (Pressure Swing Adsorption) requires, thus eliminating the high cost of the compressor and the power required for its operation.

PCI oxygen system housed on a fish-farm platform beside net pens on a lake
PCI DOCS 500 oxygen generator installed under a shelter for aquaculture

How it works

How PCI DOCS aquaculture oxygen generators work

Based on existing technology used in its military medical oxygen generators, PCI developed a commercial line of on-site oxygen generators:

The DOCS Advantage

Lowest operating cost in its class

Most reliable technology

Extremely low power consumption

Very few components = low maintenance cost

View all PCI oxygen generator products

Single-bed VSA technology

PCI Gases manufactures Deployable Oxygen Concentration Systems (DOCS), utilising a single bed state of the art VSA technology. This system is one of the most reliable, robust and cost-effective sources of on-site oxygen generation systems available.

One blower, lower costs

Utilising a single blower to both supply air to the VSA as well as remove the nitrogen and other contaminant gases from the VSA bed reduces both capital costs as well as operational costs when compared to a PSA of comparable capacity.

Load following saves energy

PCI’s Load Following feature saves energy by slowing down the VSA blower motor during periods of reduced flow.

Technology

VSA vs. PSA oxygen generators for aquaculture

To produce oxygen from air, PCI uses a proprietary Vacuum Swing Adsorption (VSA) process that maximizes sieve and power efficiencies. Such efficiencies translate into low operating costs for oxygen generation.

A VSA will save approximately 50 percent of the energy consumption over a PSA of equivalent size and delivered pressure. A VSA also eliminates 33 percent of the main components and 70 percent of the process valves, which increases its reliability and significantly reduces its maintenance costs.

Power (kWh/m³)

PSA

1.3 – 1.5

PCI VSA

0.65

Main components

PSA

6

PCI VSA

4

Process valves

PSA

10

PCI VSA

3

12 benefits of PCI DOCS oxygen generators

Factory Tested and Certified

Easy Installation (Hours not Days)

Uses Half the Power of Traditional PSA’s

No Air Compressor and Dryer Required

Oil-Free Design and Integrated Safety Features

Energy Saving Load Following Capabilities

Single Bed VSA Minimizes Process Valves and Manifolds

Remote Monitoring and Diagnostics Capabilities

Modular Design Offering Flexibility

Simple Operation and Easy to Maintain

Minimal Space Requirement

Minimal Civil Construction Work Necessary

All of these features reduce the cost of preventative maintenance and repairs, thereby reducing the operating cost.

Lower your cost of oxygen

Generate your own oxygen on site

Why pay an Industrial Gas company to supply your oxygen requirements when you can generate your own Oxygen? With a PCI Gases DOCS onsite Oxygen Generating System you can save money and…

Eliminate high cost purchased gases

Eliminate long term contracts

Eliminate ongoing price increases

Eliminate rental and handling charges

Eliminate delivery & fuel sur-charges

Potential payback

Increase in production vs. payback time on oxygen equipment investment

Line chart of payback in months against increase in production yield (50–200%) for farms producing 5,000, 10,000 and 15,000 kg/ha/year; payback falls from over 40 months to under 12 as yield rises

Models

Aquaculture oxygen generator models and flow rates

Oxygen Generator Models

Model

Power supply

Flow

Delivery pressure

O₂ purity

DOCS 80

208V / 3-Phase / 60Hz or 220V / 3-Phase / 50Hz

80 lpm

20-100 psig

93% +/- 3%

DOCS 200

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

200 lpm

20-100 psig

93% +/- 3%

DOCS 500

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

500 lpm

20-100 psig

93% +/- 3%

DOCS 2500

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

2000 lpm

3-12 psig

93% +/- 3%

DOCS 2500 Booster

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

2000 lpm

20-100 psig

93% +/- 3%

DOCS 5000

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

5000 lpm

3-12 psig

93% +/- 3%

DOCS 5000 Booster

460V / 3-Phase / 60Hz or 380V / 3-Phase / 50Hz

5000 lpm

20-100 psig

93% +/- 3%

Scroll and Explore →

FAQ

Aquaculture oxygen generator questions

How long does installation take?

Our oxygen generators are built to be light weight, compact, and basically turn-key. The installation time is measured in hours and not days, which is the case for other systems.

Can the oxygen generator be monitored remotely?

The oxygen concentrator control system includes the ability to remotely monitor critical system functions. All start/stop/alarm/monitoring can be performed from any computer once access to the internet has been established. This feature also provides the customer or PCI the ability to log-on and monitor system performance or troubleshoot operational issues.

Talk to PCI Gases

Ready to Reshape Your Tomorrow?

12201 Magnolia Avenue, Riverside, California 92503, US · +1 951.479.0860 · ox****@******es.com
PCI Gases is an ISO9001 & ISO13485 registered company

Skip to content